12/07/2011

NEXT POST
Construction Roof The most important condition when choosing a site for the construction of pavilions - a beautiful view from it. The task of the designer - to make as open as possible to review the most advantageous point of the garden (flower beds, single flowering trees, garden stones, fountain, alpine slide) and mask with unattractive (eg, patch, or hozblok trash can). TYPES arbors When it comes to form, the choice here depends entirely on your imagination and budget allocated for the construction of the arbor. In general, the arbors are: rectangular, multi-faceted, round, peaked, closed and open, with no sex or sex, massive log and exquisite trellis pergolas, arbors in the form of ancient temples and Chinese pagodas. Manufacturers of prefabricated sectional garden buildings offer a fairly wide range of ready-made houses, sheds and gazebos, and if you are comfortable with a wrench and a screwdriver, you able to collect one such instance during the day. But if you want to invent and create their own construction yard, there are several factors that must be taken into account. For the construction of pergolas STOYMATERIALY better use of softwood. It is better to buy a tree already pre-treated with a protective antiseptic. The most suitable material for the construction of pavilions is promorennaya pine. It is more available, compared with other types of wood, as well as easier to process. Oak and larch are also used for the manufacture of arbors, but this material is expensive, hard and difficult to process. In addition, oak and larch not available in all regions of Russia (in particular in the middle lane, they are rarely used.) ROOF When designing gazebos to immediately determine the type of roof. It can be a ridge or a flat (which has a slope of 5-10 degrees). If a wooden...
PREVIOUS POST
Plasterboard In order to make a ceiling made of plasterboard, we need the following: Tools. Water level, hammer, screwdriver or electric drill, angle measure twice for right angles, a knife for drywall, fishing line. Materials. Dowel nails, best 6 x 60 mm, 4 mm screws on the metal, the so-called "Seeds" screws for plasterboard, U-shaped pendants, ceiling profiles UD (28-27 mm) and SD (60h27 mm). And the actual ceiling drywall sheet 1200 * 2500 * 9 mm. If the profiles are smaller than the length or width room, you must purchase low elements. This can ask the seller-adviser. The ceiling can be single storey and three-tiered chetureh. For illustrative purposes, consider making a two-tier ceiling. First level. 1. Determination of the horizontal. Be measured height in all corners of the room. Choose the lowest angle, retreating down 4-5 cm and with a water level mark making. Then, using paint repel the cord line previously defined standards. So how do the ceiling of plasterboard for the first time we have at this stage suggest to approach the work very seriously. As they say, look before you leap! 2. Through the profile of drill holes in the wall for dowels, and then fasten it to the UD-profile (28-27 mm). 3. On the ceiling, holding the parallel lines in increments of 60 cm by the lines held on the dowel screw the nails of our U-shaped mounting hangers. 4. We stretch the line and on it at with screws anchoring the SD profiles for suspension. If the length of the room longer than the profiles, then build them using the previously acquired to connect the elements. Between the longitudinal profiles of the transverse ribs must be secured rigidity. If you plan on mounting fixtures, but he probably will, at this stage should be icing...

Recent Comments